Power, network and cameras.
One contractor on site.

ENVO installs and certifies the electrics of homes and commercial buildings, and lays everything that runs through the same conduits: KNX automation, copper and fibre, cameras, fire and intrusion detection, EV charge points. Out of Waremme, in the province of Liege.

What we install

Seven trades that share the same drilling, the same conduits and the same distribution board. That is why they are all here.

  • Electrical installation

    Homes and commercial buildings. Distribution board, circuits, lighting, sockets and controls, from the first hole to commissioning.

  • KNX building automation

    The open standard, not a proprietary hub. Lighting, blinds, heating and supervision on a bus that any KNX integrator can still program, including when that is no longer us.

  • Network and fibre

    Copper and fibre cabling, patch cabinet, active equipment, and link certification where it is asked for.

  • CCTV

    Indoor and outdoor cameras, recorder, remote access. Registering the cameras as the law requires is part of the job.

  • Fire and intrusion detection

    Detectors, panel, sirens, and alarm transmission to a phone or to a monitoring centre.

  • EV charge points

    Single or three phase, one point or a whole car park, with load management where the supply will not carry the power asked of it.

  • Bringing an installation up to code

    Survey of the defects, remedial work, and the approved inspection body’s visit prepared together with you.

A local firm, and what that changes

We are a small outfit. That is not a sales line, it is what makes the four points below possible.

One person to talk to
Whoever prices the job is whoever comes to do it. There is nobody to explain it to twice.
A quotation line by line
You see what has been counted, in what quantity, and what has not. A quotation on a single line cannot be discussed.
An installation that passes inspection
The RGIE, Belgium’s electrical code, is prepared for while the routes are being drawn, not the evening before the visit. We put the file together and we are there on the day.
A building that stays usable
We work zone by zone and put the power back on in the evening. A shop does not close because somebody is pulling cable.

Our work

The pictures below illustrate six of ENVO’s seven trades. They are not our own sites yet: those will replace them.

Board and circuits, renovated homeIllustrative photograph
KNX panel, lighting and blindsIllustrative photograph
Patch cabinet, copper and fibreIllustrative photograph
External camera on a facadeIllustrative photograph
Manual call point, industrial hallIllustrative photograph
Charge point, private drivewayIllustrative photograph